Find and stop the drip
Empty the cabinet and run the faucet. Check the two supply lines and their valves, the faucet connections underneath, the P-trap and the drain tailpiece. A drip only while water drains is a drain-side leak; a constant drip is a supply line or valve. Fix it, or have a plumber replace the lines and valves, before anything is cleaned.
How far has it gone?
- Only on the cabinet floor surface, small area, wood still firm: often a cleaning job.
- Cabinet floor swollen or crumbling: the particleboard needs replacing; mould is likely underneath it.
- Spots on the wall behind the vanity or a musty smell in the room: water may have run into the wall or under the flooring.
- Mould on the ceiling below an upstairs bathroom: the leak reached the floor cavity.
Cleaning a small area yourself
For a small patch on a hard surface (the US EPA uses about 10 square feet as the guide), wear gloves, eye protection and an N95 mask, scrub with detergent and water, and dry thoroughly. Do not mix bleach with ammonia or other cleaners. Porous material such as swollen particleboard or drywall that is mouldy should be removed and bagged, not scrubbed. Then leave the cabinet open with a fan on it until everything is dry.
When to call a remediation company
If mould is inside the wall, under the flooring, larger than a small patch, or someone in the house has asthma or a weak immune system, have it handled professionally. In Texas, mould jobs of 25 contiguous square feet or more must be done by licensed remediators following a written protocol from a licensed assessor. The remediation company removes the vanity if needed, contains the area, takes out mouldy materials and dries everything before the bathroom is rebuilt.
Common questions
Is it safe to use the bathroom?
Usually, if the mould is limited to the cabinet and you keep the doors closed and the exhaust fan running. Anyone with asthma or a weak immune system should avoid the room until it is cleaned.
Should I spray it with bleach?
Bleach can lighten mould on hard surfaces but does not fix soaked particleboard or drywall, and its fumes are harsh in a small cabinet. Remove porous mouldy material and clean hard surfaces with detergent and water.
How do I stop it coming back?
Fix the drip, replace old supply lines with braided ones, keep the bathroom fan running after showers, and do not pack the cabinet so tightly that air cannot move.
