Serving homes across Dallas–Fort Worth, TexasCall-connection service, not a contractor. About us

Water, flood, sewage, mould or fire damage?Call to reach a local restoration company

Call (866) 570-0042

Leaks & burst pipes

Washing machine valve or hose broke: what to do

A washer supply hose is under full house pressure all the time, even when the machine is off. When it bursts, it can put several gallons a minute on the floor until someone notices.

Call (866) 570-0042

First minutes

Close the two valves behind the washer (hot and cold). If they are stuck or the leak is at the valve itself, close the main shut-off. Unplug the washer only if you can reach the plug from a dry spot; otherwise switch off the laundry circuit at the breaker. Then move towels and rugs away and start removing standing water.

How far the water travels

Laundry rooms in DFW homes are often in a hallway, off the kitchen or upstairs between bedrooms, and the water takes the easiest path: under the door into hallway carpet, under the base cabinets, under the wall into the next room, or through the floor into the ceiling below. If the leak went undetected for an hour or more, assume it reached at least the neighbouring rooms. A moisture meter finds water under flooring that feels dry on top.

Hardwood and laminate near laundry rooms

Wood flooring that soaks up water starts cupping, where the edges of each board rise above the centre. Caught early and dried slowly with specialist floor-drying mats or panels, many hardwood floors flatten again over a few weeks. Sanding a cupped floor too soon is a mistake; once it dries it can crown the other way. Laminate behaves differently and usually has to be replaced if the edges swell.

Prevent the next one

  • Replace rubber supply hoses with braided stainless-steel hoses, and replace those every five years or so.
  • Leave about four inches behind the machine so hoses do not kink.
  • Install a washer drain pan, especially for an upstairs laundry.
  • Add a leak sensor or an automatic shut-off valve.
  • Turn the valves off when you are away for more than a day or two.

Common questions

How much water can a burst washer hose release?

A lot: at normal household pressure a broken supply hose can put out several gallons a minute. That is why a leak that went undetected for an hour can reach several rooms.

Do I need to replace the valves too?

If they were hard to turn or dripped when you closed them, yes. Old multi-turn valves often fail at the worst moment; a plumber can fit quarter-turn valves or a single-lever washer valve.

Is the washer itself damaged?

Usually not if the leak was in the hose. If water reached the motor or control board, have an appliance technician check it before you plug it back in.

Related reading

Call (866) 570-0042