Shut it down in this order
- Water: close the cold-water valve on the pipe above the heater. If it will not turn, close the main shut-off for the house.
- Energy: for a gas heater, turn the gas control knob to Off or Pilot; for an electric heater, switch off its double breaker at the panel.
- Pressure: open a hot-water faucet in the house so the system is not pushing more water into the tank.
Do not try to drain a hot tank yet. Water at the bottom can be scalding for hours.
Where the water goes
In North Texas homes the heater usually sits in one of three places, and each fails differently. In a garage, water runs across the slab and under the wall into the next room, wicking up the drywall and soaking carpet along that wall. In a hall closet, it goes straight into the surrounding flooring and the walls on three sides. In an attic, it comes down through the ceiling, often in more than one room, and soaks the insulation on the way.
The water from a heater is clean when it leaves the tank, which helps: if extraction starts the same day, many materials can be dried in place.
Drying and drywall
A restoration crew extracts standing water, then checks how high the wet line has climbed inside the walls. Drywall wicks water upward, so a wall can be wet a foot above the visible stain. The usual approach is to remove baseboards, drill small holes or cut a strip of drywall near the floor, and blow air into the cavity while dehumidifiers pull moisture out of the room. Drying often takes several days and should end with moisture readings at normal levels.
Drywall repair comes after drying: new board where it was cut, tape, texture to match, primer and paint.
Replacing the heater
A plumber replaces the heater, and in Texas that work needs a permit in most cities, along with a drain pan and properly routed relief valve line. Ask about a pan with a drain line to the outside and a leak sensor with an automatic shut-off valve; both are inexpensive compared with another flood.
Common questions
How do I know the heater actually failed?
Water around the base with no other source, rust streaks down the tank, or water coming from the bottom seam all point to the tank. A leak from the top fittings or the relief valve pipe may be fixable without replacing the heater.
Is the drywall in the garage worth saving?
If the water was clean and extraction started the same day, drywall often dries in place after the baseboards come off. Board that sat wet for days, crumbled at the bottom or smells musty is cut out above the wet line.
Does insurance pay for the new heater?
Usually not. Many policies pay for the water damage the burst caused but not for replacing a heater that wore out. Ask your agent which parts of the loss your policy covers.
